Publicidad
iCUE LT200 SMART LIGHTING TOWER WITH WIRELESS HUB KIT- QSG BRIEF
Out of the Box Setup
1. Remove LT200 Smart Lighting Tower from box.
2. Connect the USB-C to C cable (K) to the LT200 USB Type-C Port (B) and the USB-C
to C Wall Adapter (L)
3. Plug the USB-C to C Wall Adapter (K) into an available wall outlet.
4. Power on the LT200 by sliding the On/Off power switch (A) on the side of the
base.
5. Press the multi-function button (C) to cycle through the preset lighting effects.
The list of effects are:
•
Super X (Combination of predetermined effects)
•
Rainbow Wave
•
Color Shift
•
Color Pulse
•
Color Wave
•
Static Color
•
Sequential
•
Marquee
•
Rainbow
•
Strobing
•
Visor
•
Rain
Setting up the iCUE Wireless Hub:
1. Remove the iCUE Wireless Hub,
and
from the packaging.
USB-C to C Wall Adapter (L)
2. Use the QR code located on the bottom of the iCUE Wireless Hub (I)
to download the iCUE Mobile app or go to the App Store/Google Play
Store to search, download, and install the iCUE Mobile app.
<INSERT APP DOWNLOAD QR CODE HERE>
3. Open the iCUE Mobile app on your Android or iOS device.
4. Follow the steps within the iCUE Mobile app to set up your iCUE
LT200 Smart Lighting Tower with iCUE Wireless Hub Kit. If iCUE
Mobile has already been installed before, proceed to "Add a new
device" from the menu located on the top left of the app.
Pairing the LT200 lighting tower(s) to an iCUE Wireless Hub
1. Power on the LT200 lighting tower by
and ensure that the iCUE Wireless Hub is
(A) on the side of the base
nearby.
2. Initiate pairing by pressing and holding the multi-function button
(C) on the LT200 for 10 seconds, the LT200 LEDs will blink blue to
confirm it is in pairing mode.
3. On your iCUE Wireless Hub, press and hold the multi-function
button (F) for 10 seconds. The pairing LED (E) on the iCUE Wireless
Hub will begin to slowly blink white once in pairing mode.
4. If pairing is successful, the LT200 LEDs will blink Green to confirm.
5. If pairing is unsuccessful, the LT200 LEDs will blink Red. Repeat
step 2 and try pairing again.
Wall Mount Recommendations:
Screw head diameter ≤ Ø5.5mm
Height of screw head ≤ 2.8mm
Corsair Memory, Inc. declares that this equipment is compliance with
Directive 2014/30/EU and 2011/65/EU. A copy of the original
delcaration of the conformity can be obatined at
regulatory@corsair.com.
Label information is located on bottom of exterior of product.
Detachable USB Type-C to C Cable
(K),
sliding the On/Off power switch
Publicidad
