Publicidad
Idiomas disponibles
Idiomas disponibles
How to adjust the intensity of the massage func�on
Press the INTENSITY + or - bu�on to set the massage intensity to one of three
available se�ngs: LOW, MEDIUM or HIGH. Each se�ng is indicated by a COLORED LED light.
How to Use the Heat Func�on
To turn on or off the heat func�on, press the HEAT bu�on. There is only one se�ng for the HEAT func�on, on or off.
NOTE:
Heat & Massage system is designed with an auto-shutoff mechanism that turn off a�er 30 minutes of use.
It is recommended the heat and massage units not be used for more than 30 minutes at a �me.
WARNING: Con�nuing to hold the down Arrow
WARNING: Con�nuing to hold the up Arrow
INSTALLATION OF BACK-UP BATTERIES
2-9 Volt back-up ba�eries will operate the chair from the reclined
posi�on to the sea�ng posi�on one cycle in case of a power failure.
If a power failure occurs and the chair is cycled, the 2-9 volt ba�eries
will need to be replaced.
1. Remove the sliding door on the side of transformer to locate the
2-9 volt batteries.
2. Remove the 2-9 volt batteries and replace with new batteries.
3. Replace door on the transformer.
4. Batteries not included
TROUBLE SHOOTING PROBLEM
Chair will not operate
POSSIBLE FACTORS
Transformer may not be connected
SOLUTIONS
Check the transformer has been correctly connected to the socket Confirm with the wire from chair to transformer is
firmly connected.
SIGNATURE DESIGN BY ASHLEY
will raise the Footrest.
will li� the chair.
All Rights Reserved.
POWER TRANSFORMER
BATTERY
DOOR
2-9 VOLT BATTERIES
(Not Included)
May. 2022
00330B
Page 6 of 17
Publicidad
