Air Inlet
Never cover the air inlet. Keep it free from obstructions and
debris. It must always remain clear for proper motor cooling.
m
WARNING!
To avoid personal injury, do not wear loose
fitting clothing or articles such as scarves, necklaces, chains,
ties, etc., that could get drawn into the air inlet. To make sure
long hair does not get drawn into the air inlet, tie back long
hair.
Maintenance
Please contact an authorized Snow Joe
or call the Snow Joe
®
+ Sun Joe
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
Remove the battery before performing any
maintenance task.
If the battery is still connected, the unit could be accidentally
turned on while you are performing maintenance on it, which
could result in personal injury.
Drain the Tank
1. The tank must be drained and cleaned every time after
vacuuming. Remove the drain outlet cap by turning it
clockwise and use the drain outlet to drain the liquid
waste in the tank (Figs. 21 – 22), or remove the powerhead
to pour out any debris or dust from the tank (Fig. 23).
Rinse the tank with warm water if needed. Allow it to dry
completely.
Fig. 21
Drain
outlet cap
®
+ Sun Joe
®
dealer
®
customer service center
Fig. 22
Fig. 23
2. If paper dust bag is used for dry vacuuming, simply
remove the bag and pour out all debris in the bag.
m
WARNING!
Discard the debris and dust according to
local laws and regulations.
Cleaning the Foam Filter
m
The foam filter must be washed every time
WARNING!
after wet vacuuming.
1. Switch off the unit and make sure the battery is removed.
2. Unlock the powerhead by flipping up the latches on both
sides, and then lift powerhead up (Fig. 5).
3. Turn the powerhead upside down. Remove the foam filter
from the filter basket.
4. Clean the foam filter with soft soap under running water
and allow it to air dry.
15