Publicidad
9.Neck
1.Front Grill
10.Extension Pole
2.Grill Clip
3.Fan Blade
11.Extension Pole Nut
4.Blade Set Screw
12.Base
5.Rear Grill Screw
13.Heavy Duty
6.Rear Grill
14.Fastener for Extension Pole
7.Motor Shaft
8.Motor Housing
Assemble the extension pole onto base and heavy duty under the base by fastener
Using the fastener to tighten extension pole to base
3
Thread extension pole nut onto threads of extension pole
Take fan motor housing and insert it into extension pole and tighten the neck set screw securely
Remove four mounting screws from motor housing where indicated to use for rear grill
then assemble rear grill onto motor housing using screws, thighten the 4 screws securely
Place fan blade onto motor shaft. Tighten blade by set screw securely on flat surface on motor shaft
Attach front grill to rear grill with hook clip centered on the top above wire handle.Press remaining
grill clips onto rear grill to securely attach front grill.Do not operate fan without grill in place.
.
Turning fan on/off to start the fan,rotate control switch from"0"(off) to desired fan speed(1,2,or3).
Pushing the knob on the motor housing to start oscillation,pulling the knob to stop.
Rotating top control switch to "0"(off) position to discontinue use
4
Publicidad
