Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Trouble
The ADF does not darken when welding.
The ADF stays dark after welding or there
is no arc present.
The ADF switching during the welding.
Inconsistent shade number in the corner
of ADF.
Warranty
The auto-darkening helmets are warranted for two years from the date of purchase. The duration
of use depends on various factors such as use, cleaning storage, and maintenance. Frequent
inspections and replacement if case of damage are recommended.
Remedy
Stop welding or cutting immediately.
• Make sure the sensors are facing the
arc and no obstructions.
• Check the mode that is on WELD not
GRIND.
• Review sensitivity recommendations
and adjust sensitivity if possible.
• Replace the battery if necessary.
• Adjust the sensitivity to the lower level
(level 1).
• If the welding place is extremely bright,
it is recommended to reduce the
surrounding light level.
• Increase the sensitivity if possible.
• Make sure the sensors are facing the
arc and no obstructions.
• Increase Delay 0.1−0.3 second may
also reduce switching.
• It is a natural feature and will not be
dangerous for the eyes.
• In order to get a maximum comfort, try
to keep a view angle at around 90°.
5
Publicidad
