Publicidad
Idiomas disponibles
Idiomas disponibles
2
Intended use / guarantee
The pressurised air grease pump pneuMATO 55 is suitable for lubricating machinery, vehicles
and equipment with commercial lubricants. The pump works fully automatically.
Grease and pastes, which are based on silicone oil and thickened with PTFE, are not allowed to
be used with this device. Direct enquires to our technical department.
If used as intended and in accordance with the instructions, we are liable under the statutory
warranty. The invoice from your dealer with the date of purchase must be enclosed with
warranty claims.
3
Assembly and delivery
The structure, including the individual components, is depicted on page 3. The pumps work fully
automatically. Grease is produced once air pressure has accumulated and the trigger of the
grease gun is pressed. If the trigger is released, the pump automatically stops grease
production.
The scope of delivery is shown in the order confirmation.
Performance chart: (Multi-purpose grease NLGI class 2 at ca. 20°C)
4
Set up and operation (stationary)
-
Remove cover from grease bucket.
-
Press the grease sequence piston onto the grease in the bucket, until it is visible in the central
opening. The rubber lip must lie evenly against the bucket wall.
-
Place dust protection cover onto the bucket.
-
Push the pumping station through the clamp on the dust protection cover and the grease
sequence cover until it reaches the grease container base. Secure pumping station with wing
nut.
-
Connect high pressure reinforced rubber hose with grease gun to the pumping station.
Check all connections for a firm fit and leaks before starting the system.
-
Connect air connection to the air pump and ensure that no more than 8 bar of air pressure at the
pump is pending. Once the air supply is established, the pump independently sucks in the
lubricating grease. Keep gun now open, until the lubricating grease comes out. Afterwards
release trigger. The pump will automatically shut off after reaching the maximum operating
pressure and is ready for use.
10
MATO
/ Benzstr. 16-24 / 63165 Mühlheim a. Main / Tel:+49(0)6108-906-0 / Fax:+49(0)6108-906-120
GmbH & Co. KG
Operating instructions Pressurised air grease pump
Flow rate (cc / min)
pneuMato-55
Publicidad
