Hendi 230299 Manual Del Usuario página 12

Maintenance / Care / Repair
The perfect operation and safe use may be ensured
only through the correct use of the appliance, as
well as the compliance with the operation instruc-
tions, the corresponding specifications and the
care and cleaning indications.
This applies both for the compliance of the provi-
sions of law on appliance safety (GSG) and the ex-
isting specifications of ZH 1 and VBG on accident
prevention.
RECOMMENDATION: Before cleaning or mainte-
nance works, the appliance should not be connect-
ed with voltage through the installed main switch /
fuse. The appliance should never be sprayed with
water or high pressure cleaning aid, because any
insertion of water in the electrical elements may
affect the regular operation of the appliance as
Unloading the water from the dishwasher's tank (dispenser)
• Turn OFF the power of the dishwasher
• Empty the washing dispenser removing the over-
flow hose A.
• If the dishwasher is equiped with draining pump,
EN
follow the above mentioned steps and then press
the start button once in order to start the auto-
matically 2 minutes drainning program.
ATENTION: during the drainning program the door
must remain closed.).
Regular maintenance and cleaning works
Regularly, you should remove the rotating arms
and sprinkler, clean them carefully with water and
reposition the parts in reverse order. This work
should be performed with great care.
PAY ATTENTION TO THE CORRECT POSITION OF
FILTERS AND SPRINKLER!
• Do not clean the sprinkler's injectors with tools
or sharp objects.
• You may clean the appliance with warm water and
conventional cleaning aids. Rub with water and
then let it dry. The stainless steel parts should
be treated with special means for steel and you
should never clean them with steel wire, brush,
etc. Also, you should never let them touch the
surface, since even the lightest contact with the
surfaces may cause rust formation. You should
use brushes made of polymer plastic or natural
brushes or thin wire.
12
well as the protection against electrical shock (in-
sulating protection).
We recommend that you prepare a relevant main-
tenance agreement for all maintenance and repair
works with our company (or with a service team /
workshop of an authorized local dealer who sold
the appliance).
All works / repairs performed in this appliance
must be reported on the last page of the operating
instructions, along with the signature / company
name.
Substantially, no safety arrangement should be put
out of operation. If the disassembly of individual
safety arrangements is required, e.g. for mainte-
nance or repair works, the reassembly of the rel-
evant safety arrangements should be performed
immediately after the completion of works.
• Remove the filter B and clean it carefully with
water.
• Rinse the washing compartment to remove any
dirt residues.
• Then, reassemble the parts in reverse order. The
appliance should never operate without a filter.
• During non-operation, the door should remain
half-open or completely open (in order to avoid
odours).
• You should take care to move towards the
smoothing direction, so that you will not scratch
the surface. Finally, rinse with clean water and
dry thoroughly.
• We remind you that corrosion (rust formation) on
stainless steel surfaces is not created by itself,
but rather due to the use of improper cleaning aid
(e.g. whitening or particularly caustic cleaning
aid based on chlorine). Following a particular pe-
riod of use, calcium sediments are formed in the
internal walls of the dispenser (due to mineral
particles in the water), which may affect the cor-
rect operation of the appliance. For this reason,
regular removing of salt formations is required.
• We recommend letting this work (removing of
salt formations) to be performed by specialized
personnel (or by an authorized local dealer who
sold the appliance).