Colebrook Bosson Saunders LAP-001-INST-B-MAY2013 Instrucciones De Instalación

I N S T A L L V E S A P L A T E
I M P O R T A N T
It is the responsibility of the installer to ensure all mounting
screws are properly inserted into the mount. Under or over insertion
may cause damage to the equipment or injury to personnel.
DO NOT exceed maximum recommended load
5kG/11LB
I N S T A L L R O T A T I O N L I M I T E R S
Only applicable when fitting on Flo and Wishbone
For other arms follow standard VESA Plate Installation
I N S T A L L L A P T O P M O U N T T O A R M
Ensure that portrait/
landscape action is returned
to vertical position
N O T E
Flo shown for illustration, if you are not using Flo
please follow your screen mounting instructions
1
M O U N T L A P T O P
4A
4B
2
I N S T A L L L A P T O P C A B L E S I N T O
C A B L E M A N A G E M N E T F E A T U R E S
Lug the cables in the
housing and push up
into arm
3
I M P O R T A N T
Ensure you leave enough free cable to avoid stretching or
snagging at all positions of arm movement and monitor tilt
4
U S I N G Y O U R L A P T O P M O U N T
Once it has been correctly
set up, you will be able to
easily position your laptop
wherever you want it with
fingertip control
T I P
Ensure you have allowed enough free cable for screen rotation
When moving Laptop Mount up and down it may be easier
to support the laptop to control the head tilting
5
I M P O R T A N T
Ensure laptop mount does not go beyond vertical
6
T O R E M O V E L A P T O P F R O M M O U N T
W A R N I N G
Stored energy hazard when using Flo monitor arm.
Arm mechanism is under tension and will spring up when load is
removed. Failure to follow instructions could result in injury.
T O R E M O V E L A P T O P M O U N T F R O M A R M
PUSH
W A R N I N G
Raise arm to uppermost position before removing Laptop
Mount otherwise it may spring up when unloaded. Ensure the
laptop is not on tray when removing.
N O T E
The Laptop Mount also supports dual screen working
7
8