PPA CITROX EM 4100 Manual De Usuario

WARNING:
Do not use the equipment
without referring to this
manual rst.
USER MANUAL
125KHZ EM 4100 RFID
KEYCHAIN
LINE
P30311 - 07/2022
Rev. 0
Description
Proximity Keyrings have the same operating principle.
They operate at the frequency of 125KHz EM and 13MHZ Mifare, and use RFID communication
(identification by radio frequency).
They are passive, so they don't need a battery. They come into operation only when they are
approached from a 125KHz or 13MHz proximity reader.
They are highly reliable, have an internal code that is unique to each card.
The card can be personalized with a photo and user name, as well as a company logo, etc. The
keyring has a modern design, is waterproof and super resistant.
Dimensions:
Made by: Motoppar da Amazônia Indústria e Comércio de Eletrônicos LTDA
Praça Linear, 100, Bloco 2 - Centro
Santa Rita do Sapucaí - MG - CEP 37.540-000 - Brasil
CNPJ: 09.084.119/0002-45
www.citrox.com.br | +55 14 3407 1000
GENERAL TERMS AND CONDITIONS OF WARRANTY
MOTOPPAR da Amazônia Indústria e Comércio de Eletrônicos Ltda, registered with CNPJ
No. 09.084.119/0002-45, located at Praça Linear, No. 100, Bloco II, Centro, Santa Rita do
Sapucaí/MG, CEP 37.500-000, manufacturer of the PPA and CITROX products, guarantees
this device against defects in design, manufacture, assembly and/or jointly and severally as
a result of defects in the quality of the material that make it inappropriate or unsuitable for
the consumption for which it is intended, for a legal period of 90 (ninety) days from the date
of purchase, provided that the installation guidelines described in the instruction manual
are observed.
As a result of the credibility and trust placed in PPA AND CITROX products, we added
another 275 days to the above period, reaching a total of 1 (one) year, also counted from the
date of purchase to be proven by the consumer through the proof of purchase (Supervisor
Note).
In the event of a defect, within the warranty period, the liability of PPA and/or CITROX is
restricted to the repair or replacement of the device manufactured by it, under the
following conditions:
1. The repair and readjustment of the equipment can only be carried out by the
Technical Assistance, which is quali ed to open, remove, replace parts or
components, as well as repair the defects covered by the warranty, and, in the
absence of this and any use of parts not originals contained in the use, will result in
the waiver of this term by the consumer;
2. The warranty will not extend to accessories such as cables, screws kit, xing brackets,
sources, etc.;
3. Expenses for packaging, transport and reinstallation of the product are exclusively
borne by the consumer;
4. The equipment must be sent directly to the company responsible for the sale,
representative of the manufacturer, through the address on the purchase invoice,
properly packaged, thus avoiding the loss of warranty;
5. The replacement or repair of the equipment does not extend the warranty period.
This warranty will be void if the product:
1. Suffer damages caused by agents of nature, such as atmospheric discharges, oods,
res, landslides, etc.;
2. It is installed in an improper electrical network or even in disagreement with any of
the installation instructions set out in the manual;
3. Defects caused by falls, blows or any other physical accident;
4. For violation of the equipment or attempt to repair by unauthorized personnel;
5. It is not used for its intended purpose;
6. Not used under normal conditions;
7. Suffer damage caused by accessories or equipment attached to the product.
Recommendation:
We recommend the installation and maintenance of the product by a specialized technical
service.
If the product has a defect or abnormal operation, look for a specialized Technical Service
for the necessary corrections.