Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting kit 76596TL
1.2.3
Aligning the support frame
1. Place the lifting frame under the vehicle's frame and mount the lift arms at the eye of the jig. Use ordi-
nary bolts for the lifting platform.
The lifting frame must be parallel with the floor of the vehicle body. If it is difficult to get the lifting frame
into the correct position, loosen a hydraulic hose from the lift cylinder to release or air.
2. Tightly screw the lifting frame into the frame attachments. If lift needs to be adjusted longitudinally in the
slot. Use 4 M14x45 10.9 (120 Nm) per side.
NOTE!
Use washers on both sides of the fastening!
NOTE! A recommendation is to use the outer
of the slots and then distribute the other two
screws in the holes between.
Image 6.
www.zepro.com
Z3N/Z3NU, Z3NN/Z3NNU, Z3NW/Z3NWU 75-100
Image 5. Adjust the frame to
the ideal height under the fra-
me. A car jack is a good tool.
The fastening may be displaced in exceptional
cases. However, always use 4 screws to install
and then not more than 1 screw/slot.
Image 7.
7
Publicidad
