Publicidad
Idiomas disponibles
Idiomas disponibles
Specifications DL-1200
Model no.: DYNAMICNORD DL-1200 Dive Light
Bulb: CREE White LED (color temperature: 6500 K)
Max brightness level: 1200 lumens
Operating modes: OFF, Low brightness (25%), Medium
brightness (50%), High brightness (100%), SOS
Operating time: low 300 min, medium 170 min,
high 110 min, SOS 230 min
Reflector: glossy aluminum reflector
Lens: 4 mm toughened glass
Angle of light beam: 9°
Surface treatment: premium hard-anodizing
Battery: 18650 Li-ion battery *1
Protection against polarity reversal due to incorrect bat-
tery installation
Operation voltage: 4.2 V to 2.8 V
Waterproof: up to 100 Meters
Dimensions: 154.7 mm (length) * 41.2 mm (dia. of light
head) * 29 mm (dia. of light body)
Weight in air: 233 g. without battery; 279 g. with battery
Underwater weight: 159 g. (with battery)
Specifications DL-2000
Model no.: DYNAMICNORD DL-2000 Dive Light
Bulb: LUMINUS White LED (color temperature:
6500 K)
Max brightness level: 2000 lumens
Operating modes: OFF, Low brightness (25%), Me-
dium brightness (50%),High brightness (100%),
Strobe, SOS
8
Operating time: low 400 min, medium 250 min,
high 200 min, Strobe 500 min, SOS 200 min
Reflector: glossy aluminum reflector
Lens: 4 mm toughened glass
Angle of light beam: 9°
Surface treatment: premium hard-anodizing
Battery: 21700 Li-ion battery *1
Protection against polarity reversal due to incorrect
battery installation
Operation voltage: 4.2 V to 2.8 V
Waterproof: up to 100 Meters
Dimensions: 171.7 mm (length) * 49.5 mm
(dia. of light head) * 32mm (dia. of light body)
Weight in air: 313 g without battery; 385 g with
battery
Underwater weight: 190 g (with battery)
Low battery warning
The light flashes 3 times if the power capacity reaches
10-5%; it repeats after 5 seconds, and then switches to
lower brightness. The light switches off automatically
when the power capacity is less than 5% to prevent
over-discharging battery.
Battery installation
Holding the light with its tail pointing upward, un-
screw the light tail.
Remove the used battery from the battery com-
partment, insert a fully charged battery according
to the polarity specifications.
9
Publicidad
