Thank you for buying a genuine WINCHMAX wireless remote control kit. This two channel
kit consisting of a hand held transmitter(s) and micro receiver will allow the remote
operation of winching applications including motor solenoids and solenoid operated
hydraulic valves.
1. FEATURES
•
Remote operating range up to 100m (330ft)
•
Wide range of operating voltages 9V 30V
•
Twin outputs (IN / OUT) rated at 2.5 A
•
Tough rubber encased transmitter with LED indicator light
•
Long battery life
•
Overload protection 3A
•
Fast (0.2 second) response time for minimum overrun
•
Transmitter coded to receiver so will not interfere with other receivers.
2. PHYSICAL INSTALLATION
Warning: Incorrect connection can result in permanent damage to the receiver and will
invalidate the warranty . If in doubt seek professional advice.
•
Locate the receiver in a position protected from water or extremes of temperature.
•
Ensure all connection s to the receiver are correct and the output is less 3A.
•
Keep the receiver antenna wire as straight as possible and do not change its length.
•
The -VE power feed MUST be from a direct battery earth and not a chassis earth.3.
Connecting the Hydraulic Supply:
3. OPERATING INSTRUCTIONS
Warning: Do not use this remote for overhead hoisting or personnel carrying machinery.
In order to prevent unintended starting through tampering, RF interference or system
malfunction all machinery must be electrically isolated when not in use. Do not use
this device in any circumstances where failure or unintended operation could result in
damage or injury.
•
Press the green ON button to power up the transmitter, the red indicator light will
illuminate indicating that the device is ready to use.
•
Pressing the 'OUT' or 'IN' buttons will cause the corresponding output wires on the
receiver to go to the supply voltage.
•
When the operation has finished press the 'OFF' button to power down the
transmitter.
info@winchmax.co.uk
Wireless Remote Control User Guide
Tel +44(0)1986899266