lowcostmobile MIMO Manual Tecnico página 9

1 antenna with two outputs (MIMO) for optimal 4G/5G reception
Safety tips + installation instructions
WARNING
When you working on antenna and connection on electronic device, turn off the router,
mobile phone or Hotspot modem!
Follow instructions carefully, otherwise there is a risk of destroying your device.
Since LTE/5G technology uses MIMO technology, 4G/5G routers are now equipped with two
SMA connectors or two TS9 connectors. You can also add an adapter to connect antennas to
a Box 4G/5G or device with CRC9 (TS5) or TS9 connectors widely deployed on market by
manufacturers Huawei, Dlink, TP Link, Asus, ZTE and more. Some equipment also uses MHF4
connectors.
In order to obtain the best speed from the operator's LTE/5G network, antenna must be
installed outside in open field to appropriate transmitter.
Most 4G/5G routers detect external antenna automatically when they are connected to the
connectors. However, we advise you to block the router in "outdoor antenna" mode if
possible.
Assembly instructions
1. Find the best place outside the building and point antenna to the operator station who
covers the best your home. The operator station can be located nearest to your home or
head office, but also be a more distant antenna and not the nearest on map.
2. Outdoor antenna must, under certain conditions, be earthed in accordance with current
standards. Talk to your electrician for more information.
3. Connect antenna to the router. Use antenna only with the original cable. Do not shorten
the cable, otherwise antenna performance may be changed, and there is also a danger of
destroying antenna or the electronic device. The use of an extra extension adapter may be
considered, but knowing that you need to be careful attention to the type of compatible
adapter, adding a cable will change the performance of your connection. Improper handling
can destroy antenna connectors. We sell 2.5m, 5m and 10m extension cables of ALSR200
cable don't hesitate to contact us.
4. Turn on the router and watch the signal strength: RSRP, Cellid, through the router
interface on the appropriate page.
9/22