Taurus Alpatec HIGH LANDSCAPES CONNECT PRO Manual De Instrucciones página 11

- Add High landscapes Connect by following
the steps described in THE QUICK GUIDE.
IMPORTANT
- The device only supports 2.4GHz Wi-Fi
network.
- If the connection fails again, check the
following possible causes
- High Landscapes Connect is too far away
from the router.
- The Wi-Fi password is incorrect.
- The Wi-Fi network is not 2.4GHz
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Remove the protective plastic cover (Fig.1).
- Turn the appliance on, by using the on/off
button (8A).
- Select the appliance function / speed desired.
- After the selected time the appliance will
switch off automatically.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated
by using the speed regulator control (7A).
This function is very useful, as it makes it
possible to adapt the speed of the appliance
to the type of work that needs to be done.
TIMER FUNCTION:
- The appliance's operating time can be
controlled.
- To program the operating time simply select it
using the (3A) button.
- The time programmed or remaining time will
appear on the display (2).
LOCKING BUTTON:
- To activate this function press button (6A)
- To deactivate this function, press (6A) or (6B)
in remote control, during 5 seconds in product
display or 1 second in remote control.
NEGATIVE IONS
- When the purifier is on, "Negative ion" is
working (5).
HIGH SPEED SMOKE PURIFICATION
- Pressing speed smoke purification, the
machine runs at the highest level (six) At
this time, the efficiency of purification is the
greatest. Then press once more, will turn off
the function.(the icon of the key button is lit
when the function is working, and the icon is
not bright when it is closed.)
FILTER RESET
- This machine has a filter timing reminding
function, setting time for 1500 hours, when
the machine runs to set time. the indicator
light (9) on the panel will light up, reminding
the user to replace the filter. The reset
function of the button at this time is effective,
touch this button (1A) to reset the timing and
reopen the timing.
SLEEP MODE
- When the sleep function is opened (by
pressing 5A) the machine screen closes
and the whole light of the machine closes .
The machine will work in the sleep mode, not
controlled by the sensor. If the timing function
is opened. The machine will work until the set
time. And then will go into the standby state
- Note: in automatic mode, when the light of
the environment is less than 5-10 lms and the
duration is up to 3 minutes the machine will
automatically enter the sleep mode. When
ambient light is greater than 10 lm during
more than 5 minutes, the purifier will stop
sleep mode.
AUTO MODE
- After press "Auto" button (4A) negative ion
generator and auto icon (10) will light, and the
gear will be changed according to sensor's
data. (The icon will stay on when the machine
operates in auto mode, otherwise it will be
off.) Attention: If users change "wind speed"
under auto mode, the machine will quit this
mode automatically.
PM 2.5 DISPLAY
- The PM2.5 display sensor (11) needs 1
minute to display the data, showing the data
range of 1-500Ug/m3.
AIR QUALITY DISPLAY BAR (12)
- Green: very good quality.
- Blue: good quality.
- Yellow: general quality.
- Red: poor quality.