ledscom LC-SS-374 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Pull the connector box (1) out of the
socket column. Loosen the four screws (2)
and remove the cover of the junction box
(1). Loosen the strain relief (3).
3. Connect the building-side connection
cable to the luster terminal inside the
junction box (1) as shown in Figure 2.
4. Fix the connection cable with the strain
relief (3) and close the connection box (1).
To do this, tighten the screws (2) hand-
tight.
5. Now mount the socket column on solid
ground or with a ground spike using the
enclosed screws and dowels.
6. Turn the power back on. The installation
is completed.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Connection box
2: Screws
Figure 2
Socket column (LC-SS-374) - Assembly instructions
3: Strain relief
11/2022