Uline H-8870F Manual De Instrucciones

H-8870F, H-8874F
FREESTANDING PRIVACY
PANEL
TOOL NEEDED
Phillips Head Screwdriver
Bracket x 3
1. Separate bracket into front and rear pieces. Align
rear bracket with holes on top side of metal plate
and attach using two M5 x 6 mm screws. Tighten
screws using Phillips head screwdriver. (See Figure 1)
Figure 1
PAGE 1 OF 3
TOOL INCLUDED
Allen Wrench 5 mm
Plastic Mat x 6
INSTRUCTIONS
1-800-295-5510
uline.com
PARTS
Allen Screw x 3 Phillips Head Screw x 6
M6 x 20 mm M5 x 6 mm
2. Firmly press one plastic mat to each inside wall of
bracket. Insert M6 x 20 mm screw through hole on
outside of front bracket. Slide front bracket over rear
bracket to connect. Leave space between front
and rear bracket pieces and insert panel between
them. Firmly press the two bracket pieces together
and tighten the M6 x 20 mm screw using 5 mm Allen
wrench. (See Figure 2)
NOTE: Repeat both steps for remaining
brackets.
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
Metal Plate x 3
0321 IH-8870F