Publicidad
Idiomas disponibles
Idiomas disponibles
• DO NOT charge the unit when the temperature is below +40 F or above +120 F. It may
lessen the service life of the battery.
• This unit and its charger are designed to work together. DO NOT charge the YardSaw™
Pole Pruner with any other charger and DO NOT use this charger with any other yard
tool or appliance.
• The charger is designed to operate on 120 volts. DO NOT attempt to use it at any other
voltage.
SAVE THESE INSTRUCTIONS
OPERATIONS
• CHARGE BATTERY PRIOR TO USE – The YardSaw™ Pole Pruner does not come
fully charged when purchased. Before using the unit, the battery must be charged for at
least 16 hours. Before charging the battery, read safety and charging instructions.
• PROPER RUN TIME AND PERFORMANCE can only be obtained with a fully
charged battery.
• CHARGE TIME – Charging for about 16 hours is sufficient to replenish the battery to a
full charge. Initial use, long periods of inactivity, or storage at extreme temperatures may
require extended charge time.
Charging the Battery:
1. Plug the charger into a 120 Volt AC outlet.
2. Plug the end of the charger cord into the charge jack located on the side of the Yard-
Saw™ Pole Pruner (near the back of the control handle).
3. Charge for at least 16 hours.
4. The YardSaw™ Pole Pruner may be left on-charge indefinitely without damaging the
batteries. By leaving the saw on charge, your YardSaw™ Pole Pruner will always be ready
for use.
Charging Notes:
CAUTION: The charger can only be used with 60 cycle, 120 VAC electricity.
•
The charger unit plugged into the AC outlet will normally become warm to touch during
•
charging.
•
SAFE CHARGE – The charger uses constant current charging. The unit will not over-
charge and can be left on charge indefinitely.
Longest life and best performance will be obtained when charging at normal room tem-
•
perature.
Battery life is dependent on usage, storage temperature and time.
•
BLADE INSTALLATION/REMOVAL
WARNING: Never touch the control end of the YardSaw™ Pole Pruner, nor allow anyone
else to touch it when installing or removing the blade. Severe injury could occur if the saw
is turned on while handling the blade.
Installing the blade
• Insert the provided hex key wrench in the blade clamp screw on the left side of the saw
head. Loosen the screw 5 to 8 turns by turning counterclockwise.
• Insert the blade through the slot in the front of the saw head and in between the blade
carrier and blade clamp. See Figure-1. Insert the blade until the "INSERT" line on the
blade is even with the end of the blade clamp. Also ensure that the slotted hole in the
blade lines up and slides onto the pin on the blade carrier.
4
Publicidad
