Fontastic Pero Manual Del Usuario página 6

GB
Getting Started
Charging the headsets
Insert the headsets into the charging case slots. Close
the charging case. By closing the charging case, the
headsets get contact and are automatically charged in
the case.
Charging the case
Charge with cable: Connect the charging cable that
came with the case to the Type-C
case and a travel charger or USB port of a computer to
charge the built-in battery.
The charge status indicator flashes while charging and
lights up solid when fully charged.
Switching On/Off
Automatic:
Take both headset units out of the charging case, they
turn on automatically. Put the headsets into the charging
case and close it, the headsets turn off automatically.
Manual:
Tap and hold the multifunction sensor for 5 seconds,
the headset will turn on.
Tap and hold the multifunction sensor for 5 seconds,
the headset will turn off.
Note: Both headsets turn on and off automatically
when removed from the case or inserted.
9
charging input of the
®
Pairing
The Pero headset must be paired with a Bluetooth
enabled device to be used.
1. By removing both headset units from the charging
case, they will automatically turn on, sync with each
other, and enter pairing mode to connect to a
Bluetooth source.
®
2. Search for „PERO" on your Bluetooth
device and select it from the list of found devices to
pair the headset with the Bluetooth device.
Note: The headset units can also be used separately.
Note: When the headset is placed in the charging
case, the connection is interrupted. As soon as
both headsets are removed, they will automatically
reconnect. If the headset units do not connect auto-
matically or an existing connection is disconnected,
switch both headsets off and on again either by
inserting and removing them from the charging case,
or manually.
Note: If the headset does not find a Bluetooth
bled device, it switches off after approx. 3 minutes.
Music Control
All control commands are executed with the
multifunction sensor.
GB
®
enabled
®
-ena-
®
10