Palmer iller Manual De Instrucciones página 12

USER MANUAL
iller
1
CONNECTIONS
1. INPUT
Line input with combo jack (XLR / 6.3 mm jack) suitable for both unbalanced and balanced cabling.
Use a shielded audio cable to connect, for example, a keyboard to the Line Isolation Box.
2. OUTPUT
Balanced line-out via 3-pin XLR jack. Use a shielded audio cable to connect the Line Isolation Box to a balanced
input of a mixing console or audio interface.
3. LIFT / GND
Switch for disconnecting the ground connection from the input and output (ground lift). In the non-pressed position,
the ground connection is disconnected; the connection is established when the switch is pressed. The ability
to prevent a humming loop using the ground lift switch depends on the grounding of the connected device. It is
therefore possible that the switch is able to effectively reduce or eliminate humming when it is either up or down,
depending on circumstances.
CAUTION:
channels of mixing console and audio interfaces, etc. are muted when plugged in. Otherwise, noise
levels may cause damage.
NOTE: Strong magnetic fields can cause humming. Therefore, do not position the Line Isolation Box near
strong magnetic fields (e.g. mains transformer).
EN
3
Connecting signal cables can cause considerable noise. Please make sure that the input
2
1-Channel Line Isolation Box
passive
12