Publicidad
Idiomas disponibles
Idiomas disponibles
5.
OPERATING INSTRUCTIONS
NOTE:
the appliance temperature can reach very high temperatures. Use the
supplied cold handle to operate the air slides and open/close the door.
*
Light the appliance using the Swiss method. This method requires the appliance to be
lit from top to bottom. This ensures complete, clean and responsible combustion with
minimal emission of dust and smoke. Proceed as follows:
*
If a throttle valve is fitted in the flue gas discharge, open it fully.
*
Move the air control slider to the fully open position, which is fully to the right.
*
Stack the pieces of wood crosswise at a small distance from each other, from thick to
thin. Stack some kindling wood crosswise on top of this. Place the firelighter at the very
top.
*
Then light the firelighter so the fire burns from top to bottom. The wood heats up
slowly, which means it will burn longer and the fire will be more controlled.
*
Close the door in the ajar position (see Appendix 2).
*
The fire will slowly draw down and ignite the large logs at the bottom of the pile.
*
The door can now be fully closed and the control slider closed a little; for example, until
the tip of the flame is level with the front of the door.
CAUTION
THE INSIDE OF THE COMBUSTION CHAMBER CAN BE DAMAGED IF THE FIRE
APPLIANCE IS LOADED TOO ROUGHLY
*
Place 2 split logs lengthwise from front to back a few centimetres apart in your appliance. (2 logs of
0.7 kg of 20 cm long each).
*
Close the appliance door completely again. (See Appendix 2)
*
The combustion speed can be regulated with the air slider under the door, moving
it to the left results in a reduced air supply.
*
When the flame is controlled using the air slider and is level with the front of the
door (see Appendix 2 Fig.1), the appliance is burning at its nominal combustion rate.
*
Fill the appliance regularly and as needed, but no more than the prescribed load, see
technical data.
*
Never load with solid and/or liquid fuels other than dry wood.
*
If the ash bed becomes excessive over time (primary air openings in the front and back of
the appliance are blocked), scoop out the ash.
*
If the draft in the appliance/chimney is too high, the draft in the appliance can be
tempered by closing the efficiency plate (see Appendix 3, Fig. 4). To do this, remove the
baffle plate (see Appendix 3, Fig.3) by lifting it slightly at the front (1), tilting the plate (2) and first
removing it from the appliance using the underside of the plate (3). The efficiency plate can then be
adjusted by loosening the nuts. (4 and 5)
*
If the draft is still too high when the efficiency plate is in the maximum closed position, a flue gas
damper must be installed in the discharge pipe.
*
If your appliance becomes overloaded and threatens to overheat as a result, the air supply must be
closed completely. In this case, never open the door of your appliance (and certainly not
in the event of a chimney fire!).
Installation and operating instructions
16
Control
slider
Instructional
video
Control
slider
Trimline Woody Loft
Publicidad
