Palram CANOPI Skylight Folleto De Información Sobre El Sistema página 5

EN INFORMATION
DURING ASSEMBLY
Panel (#9633) is not pre-drilled; therefore you must drill the holes with accordance to your
• •
chosen option.
Metal plate (#8075) is used for mounting the shelf onto either one of the shed's corners. If you
• •
did not choose this option, there is no need to use this part; keep it for future use if needed.
Tighten all screws when completing assembly.
• •
When encountering these icons, you are requested to either keep the screws slightly loose
• •
or to fully tighten the screws.
ATTENTION!
Do not mount more than 2 shelves onto one panel.
• •
Do not mount more than 4 shelves on a single wall.
• •
Under any circumstance do not mount more than 10 shelves per shed.
• •
A single shelf can carry up to 30 kg (66 lbs).
• •
4 OPTIONS
Option 1:
Mounting the shelf in the middle
of the side wall
(Not suitable for 4x6 / 1.2x1.8 shed)
Option 3:
Mounting the shelf where the shelf's
right side connects with the shed's corner
Option 2:
Mounting the shelf where the shelf's left
side connects with the shed's corner
Option 4:
Mounting the shelf side by side
(only at the shed's rear wall)
(Not suitable for 4x6 / 1.2x1.8 shed)