Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP FOR HARD SURFACE CLEANING
Attach
FAUCET MOUNTING KIT
drain
Use supplied faucet adaptor kit as necessary to fit coupler to
faucet.
Connect fresh water coupling to faucet.
plied faucet adaptor kit as necessary to fit coupler to faucet.
Connect fresh water coupling to supply hose.
For best cleaning results, use hot water.
Attach waste water hose to waste coupling.
Direct drain tube into drain.
Connect water supply hose to fresh
water inlet.
Connect waste water drain hose to
waste water outlet.
Connect power cords
under the bottom of the control panel. Secure plugs
with clip. Plug each cord into a separate 15 amp cir-
cuit.
Separate Circuit Indicator light
glow green when unit is properly connected to two
separate 15 amp power circuits.
Turn on water supply at faucet
for leaks.
Pressure adjustment knob
Open tank lid, place one defoamer
pellet in filter box, replace lid.
Accessory vacuum inlet.
when not in use.
Accessory solution outlet.
The VT1200 is now ready for use.
49-091B VT1200-115V 2014-05
to water supply and
Sockets are located
will
and check
Keep covered
VISIT WWW.VERSACLEANSYSTEMS.COM
Fresh water
to VC1200
Use sup-
5
Wastewater
to drain.
Legend Brands, Inc.
Publicidad
