SurfaceMaxx SGY-PWA1088 Manual De Instrucciones

Pro Foam Cannon Quick Setup:
With the sprayer removed from the bottle, fill bottle with warm water and soap made for foam cannons
(not included).
ASSEMBLY INSTRUCTIONS
1. Attach the bottle of soap directly to
the sprayer. Turn sprayer "clockwise"
until tight (see Figure 1-1). Do not
overtighten.
2. Additional inlet threads in the spray top
will attach directly to a 16-oz soap bottle
(not included, see Figure 1-2).
3. Connect pro foam cannon to quick connect fitting on
you spray gun or wand.
Note: Pressure washer should be turned off during
connection or the trigger should be in locked position.
OPERATING INSTRUCTIONS
1. The air intake knob (A) adjusts the amount of foam. Turn
clockwise for more foam and turn counter clockwise for less
foam (see Figure 1).
2. The cone (B) adjusts both the direction of the spray pattern
(horizontal or vertical) and the width of the spray pattern.
3. To adjust the spray pattern, pull outward on the cone
and turn it clockwise or counter clockwise depending
on what direction you want and then push the cone
back in towards the intake knob (see Figure 2-1).
4. To adjust the width of the spray pattern, make sure
the cone is pushed in and then turn the cone clockwise
for a bigger fan pattern or counter clockwise to reduce
the amount of fan. It can be reduced down to a straight
stream (see Figure 2-2).
INSTRUCTION SHEET
1-1
2-1
Pull
1
ITEM #5227916
Pro Foam Cannon
MODEL #SGY-PWA1088
1-2
2
1
A
2-2
B
B
www.surfacemaxx.com