Publicidad
Idiomas disponibles
Idiomas disponibles
Keep hands clear when closing lid. Failure to do so could result in severe injury.
Read and understand all instructions and warnings before operating or using this product.
Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer
disclaims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product.
TOOLS REQUIRED- One wrench with 7/16" socket.
PADLOCK INFORMATION- Padlock with 7/8"–1" shackle
height (figure 3) (recommended Master No 5 or equivalent,
not included).
1. Open your padlock and slide the U-bolt over the lock
shackle.
2. Slide the lock through the lock housing on the front of
the box (figure 1).
Figure 4
SIDE VIEW
PADLOCK INSTALLATION INSTRUCTIONS
Figure 1
TO INSTALL RAPID PASS™ RUBBER HOLE PROTECTOR
TOOLS REQUIRED- Hammer and flat blade screwdriver.
1. Locate the "knockout"
2. With a screwdriver and hammer, carefully punch out the "knockout" from the inside of the box
so that metal ring will fall outside box (figure 4).
3. Place the Rapid Pass™ rubber hole protector from the outside of the box in the hole and be
sure that it is properly seated. BE SURE NO SHARP METAL EDGES ARE EXPOSED (figure 5).
4. When passing cords into the box, be sure to always enter box from the rear. After head of
cord is in place, slightly pull back 2-3" to ensure weather resistant "star bursts" are facing toward
the outside of box (figure 6). Never push the cord from inside the box so that mating plug points
are exposed to the environment
5. BE SURE TO FOLLOW ALL ELECTRICAL SAFETY PRECAUTIONS.
Figure 5
INTERIOR VIEW
WARNING
ATTENTION
NOTICE
U-Bolt
Lock Shackle
Figure 2
3. Guide the U-bolt through the two holes in the back of
the lock housing (figure 2).
4. Secure the U-bolt with the two nylon lock nuts supplied.
5. Repeat the procedure for the second lock.
6. To lock, close lid and push bottom of padlock until lock
"clicks" closed.
7. To open, turn key and open lid.
2
7/8"-1"
Figure 3
(measure height
when lock is closed)
Figure 6
EXTERIOR VIEW
Publicidad
