Publicidad
Idiomas disponibles
Idiomas disponibles
Capacity
Power Source
Environment
Operating temperature
Min/Max fork height
Features weighing accuracy
Width over forks
Fork Length
2.1 Assemble the indicator
2.2. Assemble the tiller and pump unit
2.2.1. Insert the tiller into the right piston of the pump
(303), then assemble the axle (G105) on the tiller and hit
the axle with a hammer from the right to the left, to make
the tiller well connected with the hydraulic pump (see
figure 1).
2.2.2 Put the fingertip control (G117) to the lower position,
then pass the adjusting nut (G104), adjusting bolt (G103)
and chain (G102) through the hole of the axle (G105)
manually.
2.2.3 Press the tiller (G110) down, take away the spring
which fixes the spring cap (302).
2.2.4. Put the fingertip control (G117) to the lift position,
then raise the lever rod (319) with the pin and insert the
adjusting bolt (G103) into the front slot of the lever rod
(319). Note: keep the adjusting nut (G104) underneath the
lever rod.
2500 kg
6V DC
General purpose, dry
-10°C — 40°C (14°F to 104°F)
85mm/200mml
+1,0kg for loading de 2,500kg
570mm
5 1150mm/ 1220mm
Fig.1
2.2.5 Tap another spring pin (G106) into the axle with hole
(G105) with a hammer. The tiller is then assembled to the
pump.
2.3 Adjust the release device
On the tiller of the truck, you can find the fingertip controls
(G117) of three positions:
Lower Position - pull up the fingertip control
Neutral Position - place the fingertip control at center
position
Lift Position- push down the fingertip Control
The three positions of the fingertip control have been
adjusted before delivery. If there are some changes due to
unexpected reasons, make adjustment according to the
following instructions:
2.3.1. Place the fingertip control (G117) in the Neutral
Position and swing the tiller up and down. At this time, the
forks should neither go up nor go down. If:
A) the forks go up, turn the nut (G104) clockwise until the
forks stop lifting.
B) the forks go down, turn the nut (G104) counterclockwise
until the forks stop lowering.
2.3.2. Pull up the fingertip control (G117) in the Lower
Position and swing the tiller up and down. At this time, the
forks should go down steadily. If not, turn the nut (G104)
counterclockwise until it starts lowering, then repeat step
3.1.
2.3.3. Push down the fingertip control (G117) in the Lift
Position. If the forks don't go up, turn the nut (G104) or
screw (318) clockwise until the lifting control (G117) can lift
the forks. Then follow step 3.1 to check the neutral position
to make sure the nut (G104) and screw (318) are in place
Publicidad
