Lionelo Tulia Manual De Usuario página 7

3. Mesh extension direction (fig. 3)
The mesh part of this gate can be rolled out from any angle, please make sure
the position you need before installing. (3-1, 3-2)
Note: Do not use this gate if it cannot be installed to walls,doorframes or posts
tightly and flatly.If the gate is not installed vertically,the locking system will be
hindered.
4. Attaching the locking hooks (fig. 4)
To install the locking hooks,first cut the template at the dotted lines as
shown,locate the frame/stud and overlay the template on the directly on it.
Install the locking hooks to both sides of the wall/door opening.with the screws
(G) provided. Use the screw & rawl plugs (G, K) provided if mounting onto
a concrete or brick wall. If mounting on any other wall materials, be sure to
use an appropriate fixing system. Refer to figure (4-1 A - Locking Hooks B
- Locking Brackets). Pull out the gate, see Operating, place and hold one of
the hooks (D) in the upper hole in the handle (F), position the hook on to the
wall/frame, according to figure (4-2) so that the gate is properly stretched.
Mark and, if needed drill holes, mount the hook on the wall /frame with the
screws (G). Repeat this procedure for the lower hook, make sure that the gate
is properly stretched.
5. Instructions (fig. 5)
Align the markings on the gate to the arrow show on the upper locking bracket.
Refer to figure (5-1). And align the lower part of gate to lower locking bracket.
Snap the gate in the place until you hear a clicking sound. Refer to figure
(5-2 A -lock).
To release the gate from the upper locking bracket,push the latch towards the
wall and pull the gate up to release. Refer to figure (5-3 B - unlock).
6. Operating
The Retractable Safety Gate is easily operated one-handed.
7. To close the Retractable Safety Gate (fig. 7)
7-1. Push down the middle button on I (width memorized button) and pull up
button I at the same time. Now the mesh is free to extend.
‑ 7 ‑
EN