Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Motor rated voltage and rated power
Floor brush rated voltage and rated power
Lithium Battery
Charger Input
Charger Output
Charging Time
Noise
Approximate Continuous Working Time
Approximate Continuous Working Time
TROUBLESHOOTING
Issues
Not Working
Weak Suction/
Trash Dropping
Down Tube
No Light When
Charging
Battery Not Full
After Charging
Floor Brush Not
Working
NOTE: The machine may overheat with prolonged use of high-speed mode and may have a
slight plastic odor. This is normal and not cause for concern. In this case, leave the appliance
to cool down for 30 minutes before using it again.
Causes
• No Power
• Brush obstructed
• The Dust cup is full
• The HEPA filter is full
• The Floor brush or Electrical
Stretch Tube has been clogged
by hair or trash
• The Adaptor's connector is not
inserted properly
• The Battery or adapter is broken
• Charging time is too short
• Battery is aging
• Large particles or objects vacu-
umed
• Resistance is too strong
• The Brush roll is entangled by
hair or wire
22.2V 250W
22.2V 15W
22.2V 2200mAh
100-240V ~ 50/60Hz
27V ~ 0.5A
4 - 5 Hours
≤ 70dB
High Mode: 15 - 20 min
Regular Mode: 35 - 40 min
Solutions
• The Battery needs to be charged.
• Restart machine
• Clean the dust cup
• Clean or change the HEPA filter
• Clean the floor brush or
Electrical Stretch Tube
• Push the adapter's connector
into the correct position.
• Contact customer service
• Charge for 4–5 hours
• Replace Battery
• Clean the floor brush and restart
the machine.
• Turn off the machine. Hold the
floor brush above the floor or
surface and restart.
• Clean the brush
8
Publicidad
