GMC 84254928 Guia De Inicio Rapido

GMC Heavy Duty Sierra
Splash Guard - Rear
Please read instructions thoroughly before starting.
Tools Required
T15 Torx Screw Driver
Trim Tool
Clean Cloth/Rag
Parts Required from Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
Rear Installation Procedure
Note: Do not use power tools to install splash guard fasteners
1. Without Removing the rear tire, remove existing screws at
locations (A), (B) and (C) and save for reinstallation.
See figure 1.
2. Remove existing screws at locations (D) and (E) and save for
reinstallation. See figure 2.
3. Pull downward to disengage existing rock guard from wheel
flare. If there is a clip, use trim tool to disengage, then pull
guard outward and down to remove. See figure 2.
4. Clean and degrease body panel where splash guards are to
be located.
5. Place splash guard to vehicle taking care to align the outboard
tab with the inner wheel flare slot. Reinstall screws at locations
(A), (B) and (C). Hand tighten only. See figure 3.
6. Reinstall screws at locations (D) and (E). Hand tighten only.
Note: Screw at location (E) does not hold the splash guard.
See figure 4.
7. Press splash guard flush against vehicle to remove any gaps
and tighten all screws to a max torque of 3.0 N m.
See figures 3 and 4.
8. Repeat for other side.
9. Guards can be cleaned with any commercially available
cleaner.
Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
AUTH
REVISION
FIGURE 1
A
EXISTING
SCREWS
FIGURE 2
EXISTING
SCREWS
FIGURE 3
EXISTING
SCREWS
A
FIGURE 4
EXISTING
SCREWS
IR 02NO18
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Splash Guard - Rear
84254928
PART NO.
C
B
D
C
B
D
84254928
SHEET
SHEET
E
OUTBOARD
TAB
E
1 3
OF
1 3
OF