VONROC WC502AC Traducción Del Manual Original página 9

2. MACHINE INFORMATION
Intended use
Your wall chaser has been designed for making
slots in masonry. The machine is only suitable for
right-hand use.
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Slot width
Slot depth
Cutting disc
Diameter:
Bore:
Spindle thread
Protection class
Weight
Sound pressure L
PA
Acoustic power L
WA
Uncertainty (K)
Vibration (main grip)
Vibration (auxiliary grip)
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
WWW.VONROC.COM
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 5.
1. On/off switch
WC502AC / S_WC502AC /
2. Lock-off button
S2_WC502AC
3. Locking knob for slot depth
230V~
4. Scale for slot depth
5. Spindle lock button
50Hz
6. Guard
1700W
7. Base
4000 min
-1
8. Guide roller
9. Dust extraction connection
14/19/29mm
10. Main grip
5-40mm
11. Auxiliary grip
12. Allen screws
150mm
13. Allen key
22.2mm
14. Spindle
15. Outer flange
M12
16. Flange key
IP20
17. Cutting disc
5.1kg
18. Spacers
85.3 dB(A)
19. Cutting disc
20. Spindle sleeve
96.3 dB(A)
21. Inner flange
3 dB(A)
22. Dust extraction adapter
7.214 m/s
2 23. Laser
24. On/off switch for laser
5.843 m/s
2
25. Battery compartment
1.5 m/s
2
3. ASSEMBLY
Replacing the cutting discs (fig. B ­ D)
Worn or damaged cutting discs must be replaced
immediately.
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
- Only use sharp and undamaged cutting
discs.
- Only use cutting discs that are suitable
for the material to be worked.
- Only use cutting discs with a maximum
permitted speed that is equal to or
exceeds the maximum no-load speed
EN
9