Michelin 1126002279 Manual De Instrucciones página 12

EN
Work by exerting a light uniform pressure on the pneumatic MULTI-TOOL to avoid
any blockage or breakage.
SCIAGE :
1. Only use saw blades that are in very good condition in order to prevent breakage and injury.
2. Check for hidden nails and screws.
3. Plunge-cut sawing should only be performed on soft materials such as wood or a plasterboard.
SCRAPING:
1. Use a high speed for scraping. Keep the MULTI-TOOL flat for optimal use.
CUTTING:
1. The carbide disc can wear out quickly depending on the hardness of the piece to be cut.
SANDING:
1. Be sure to use the abrasive sheet suitable for the material to be sanded. Do not press the pad too hard to avoid damaging the
abrasive sheet too quickly.
Disconnect the tool from the air supply before changing accessories, servicing, performing maintenance and replacing or repairing
damaged parts.
1. Use only genuine parts. Unauthorized parts can be dangerous and will void the warranty.
2. Lubricate the tool every day with a few drops of oil in the air intake.
3. Clean the tool after use. DO NOT use worn or damaged accessories.
4. When not in use, unplug the unit from the air supply and store it in a dry and safe place.
A loss of power or action may be due to the following:
a. Loss of air pressure. Moisture or blockage in the air hose. Wrong size or type of hose fittings. Check air supply.
b. Dirt or rubber deposits in the air tool can also reduce performance. If the model has an air filter (in the air inlet), remove and clean it.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to wear from normal use. These operations should ONLY be
performed by a licensed professional technician. Never try to repair the tool by yourself.
TROUBLE SHOOTING
Disconnect tool from air supply before performing any service procedure.
WARNING
SYMPTOM
Tool working at normal speed but
1
losing power.
Tool working slowly.Little air
2
circulating.
Tool not working and air circulating
3
freely.
4 Tool does not turn off.
5 Other
PRECAUTIONS FOR USE
MAINTENANCE
TROUBLESHOOTING
PROBLEMS
• Worn motor parts.
• Rotor blades worn or blocked due to lack
of lubricant.
• Mechanical parts wedged with dirt
particles.
• Power regulator in closed position.
• Air flow blocked by dirt.
• One or more motor rotors are blocked
due to dirt particle accumulation.
• Air inlet ring "D" blocked.
12
SOLUTIONS
• Lubricate the unit.
• Replace rotor blades if necessary
(contact dealer).
• Check the air inlet filter for blockage.
• Pour lubricating oil into the air intake as
directed.
• Lubricate the tool.
• Press on the motor housing gently with
a plastic mallet.
• Unplug the unit. Try to turn the unit by
hand.
• Replace ring "D" (contact dealer).
Contact your local dealer for service.