Overmax Flow Control Manual De Usuario página 12

Add device manually (fig. 6)
1.
Plug the socket into a power source. Connect your phone to a Wi-Fi
EN
network that your device will connect to later.
2.
Select Flow Control from the list (fig. 7).
3.
Select Wi-Fi network which the device is to connect to. Enter password
and click „Next" (fig. 8). Note: Only Wi-Fi 2.4.GHz networks are supported.
4.
If the device light does not flash fast, reset it by holding the on/off key
for 5 sec. (fig. 9).
5.
When adding, the device must be close to the router (fig. 10).
6.
The message „Successfully added" (fig. 11) means the device has been
successfully added. Now you can select your device from the list of
devices.
Main panel
1.
In main panel you can find time settings and wear level (fig. 12).
2.
You can switch the device on and off through the main key.
Wear
It is possible to monitor the wear level, with month and year division (fig. 13).
Schedule
1.
Select „Add schedule" (fig. 14).
2.
Select days and time at which a specific event is to occur, and then
click „Save" (fig. 15).
Timer
Set time after which a specific event is to occur (fig. 16).