ledscom LC-L-228 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the mounting plate (1) by
loosening the screws (2). Then carefully
lay the light on its side so that it cannot be
damaged.
3. Drill holes (6 mm Ø) in the mounting
base and insert the supplied dowels there.
The positioning of the holes should
correspond to those of the screw holes (3)
on the mounting plate. Make sure that the
dowels are flush with the substrate.
4. Then fix the mounting plate (1) to the
mounting base using the screws provided.
5. Connect the wires of the cable according
to "Figure 2".
6. Place the light back on the mounting
plate (1). Then retighten the screws (2) to
fix the light to the mounting plate. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Mounting plate
2: Screws
Figure 2
Reading lamp (LC-L-228) - Assembly instructions
3: Screw holes
03/2023