Sierra AC12340 Manual De Instalación

EN Installation Manual
USA and Canada
Service Office Dometic
1 Sierra Place
Litchfield, IL 62056-3029
877-663-8396 (option 1)
1 Installation

WARNING: ELECTRICAL SHOCK AND/OR FIRE HAZARD. Failure to
obey the following warnings could result in death or serious injury:
• Follow all wiring instructions supplied with replacement devices to ensure
proper installation.
• Never alter the adapter or cordset connectors.
• If the polarity warning indicator in the boat is activated, immediately
disconnect the adapter/cordset. Consult a qualified electrician to correct the
fault.
I
Sierra adapters and cordsets are compatible with all other brands of industry
standard inlets and adapters. All Sierra adapters and cordsets include a
threaded sealing ring for use with threaded inlets and adapters.
1.1 Connecting the power
1. Turn off the power supply to the boat.
I
An LED located in the connector end glows red when the adapter/
cordset is powered. Always treat the adapter/cordset as if it is
powered, even if the LED is not lit.
2. Connect the adapter/cordset to the boat inlet.
3. Connect the adapter/cordset to the dock power receptacle.
1.2 Changing the connection ring
q
1
Removing the connection ring
Connection ring
q
4. Apply a soapy solution around the base of the ring as a lubricant.
5. Remove the connection ring taking care to prevent damage to the assembly.
I
The use of a screwdriver may be required to remove the connection
ring.
AC12340, AC12350, AC12360, AC12370,
AC12380, AC12430, AC12440, AC12450,
AC12460, AC 12480, AC12500, AC12510
Service center and dealer locations
Visit: www.sierraparts.com
Form No. 4445103977 2023-03-38 | ©2023 Sierra International LLC
2 Maintenance

WARNING: ELECTRICAL SHOCK AND/OR FIRE HAZARD.
Failure to obey the following warnings could result in death or
serious injury:
• Always disconnect the adapter or cordset from the power source prior to
performing maintenance.
• If a connection shows signs of overheating, remove the adapter/cordset from
service immediately and inspect the system for further damage.
Components of this adapter/cordset are corrosion resistant however, periodic
cleaning and protecting of exposed parts can increase overall product life.
Before every use:
• Inspect the adapter/cordset ends, boat inlet face, and the dock power
receptacle.
• Check the adapter/cordset ends for discoloration which may indicate
overheating.
In the event of saltwater immersion:
1. Rinse the adapter/cordset end with fresh water.
2. Shake or blow out any water.
3. Allow the adapter/cordset to air dry.
4. Coat the adapter/cordset end with an antioxidant spray.
When not in use, store the adapter/cordset indoors to maximize the cord life.
3 Troubleshooting
Problem Possible Cause
Overheating • Corrosion buildup
• Faulty connection
30A and 50A cordset
15A, 30A, and 50A shore
power adapter
Recommended Solution
1. Visually inspect the adapter/
cordset ends for corrosion.
2. Visually inspect the dock power
receptacle for corrosion.
3. If corrosion is found, replace the
adapter/cordset immediately.
WARNING
Cancer and Reproductive Harm
www.P65Warnings.ca.gov