Freedom Horizontal Privacy Vinyl Gate Kit Instrucciones De Instalación página 4

Full Privacy with Decorative Screen Panel Topper
2b
(3 rails):
a. Turn stile sideways and insert arrow end into slit
in rail (Fig. 5).
b. Rotate stile 90 degrees so the opening is facing
the center of the rail. Be sure to leave about
4-3/8" from the end of the rail (Fig. 6).
c. Apply provided vinyl cement to all inside surfaces
of the uprights where the rails will be installed
(Fig. 7).
d. Install rails into upright in the orientation shown
(Fig. 8).
NOTE:
Mid-rail will have a slit in the top for the
Decorative Screen Panel insert.
4
Top Rail
Mid Rail
Pre-installed Stile
Bottom Rail
Fig. 5
Fig. 6
4-3/8"
Fig. 7
Fig. 8
Push Stile Flush
to Channel Strip