Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging. If the device has been
exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your device. Leave the device switched off until it has reached room temperature.
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the device can be irreparably damaged. The product must
also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. Power
Press to switch the device on/off
2. Aux in jack 3.5 mm
3. Treble
Rotate to adjust the high frequencies
4. Mid
Rotate to adjust the mid frequencies
5. Bass
Rotate to adjust the low frequencies
6. Balance
Rotate to adjust the balance between L and R channel
7. Volume
Rotate to adjust the volume level
8. Infrared remote control sensor
9. AUX select
Press to select AUX input
10. LINE select
Press to select LINE input
11. DVD select
Press to select DVD input
12. BT select
Press to select BT input
1. BT antenna connector
2. RCA input
RCA line and -DVD input sockets
3. Line output
RCA line output sockets
4. Subwoofer output
Output for connecting a separate
subwoofer
5. Speaker output
Binding post speaker output
connectors
6. AC input and fuse holder
Socket for plugging in the supplied power cord (top). For instructions on how to change the fuse (bottom), see
"REPLACING THE FUSE"
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
5
Publicidad
