Nash Siren R4 Manual Del Usuario página 10

MUTE/VIBRATE:
Press the and hold the Vibrate/Mute
3 seconds to cycle through the options for Receiver
function:
1. Vibrate and LED flash - receiver muted, vibrate alert
2. LED flash only - receiver muted. LEDs on, no sound
3. Bleep, LED flash and Vibrate - sound, LED and
4. LED flash and a bleep - sound and LEDs on.
SETTING LED BRIGHTNESS:
Press and hold the Volume button
the Power
low LED brightness levels available. Release the Volume
button to select the brightness level.
ANTI-THEFT ALARM:
Press and hold the Theft Alarm
The Receiver will sound 2 bleeps of increasing pitch and
the LED second from the right will flash green to indicate
the anti-theft alarm feature is enabled. The Receiver will
sound 2 bleeps of decreasing pitch and the LED will flash
red to indicate the anti-theft alarm has been disabled.
RUN/DROP BACK REGISTRATION:
The Receiver will signal line movement from an alarm on
the paired channel, replicating tone and the LED colour
of the paired alarm head, but at the LED brightness and
volume selected on the Receiver. Drop Back indications
are signalled by three descending low tones.
REAR LED FUNCTION:
R4 alarms feature our unique Homecoming Mode. This
feature is an LED located at the rear of the alarm body,
designed for safe navigation in the dark back to a swim
when using boats. This LED function is controlled by the
Receiver.
10
Instruction Manual.indd 10 Instruction Manual.indd 10
and LEDs on. (Factory Setting)
and no vibrate.
vibration turned on.
button to toggle between the high and
button for
V
, then short press
button for 3 seconds.
A
25/01/2022 12:3 25/01/2022 12:3