AENO RC1S Guia De Inicio Rapido página 10

body, and do not use the device in wet areas such as bathrooms. Do not place
the device in areas where it can easily fall (Tables, chairs, stairs, high platforms,
etc.). Before dry mopping, make sure to install the dust container ❻.
Please note that bright and direct sunlight, as well as very dark surfaces
influence operation of infrared sensors of the vacuum cleaner. For example,
dark surfaces are taken as obstacles. So, it is recommended not to leave dark
carpets or fabrics on the floor, and cover windows with curtains on a sunny day.
Before operating the device, you should remove all sensitive or potentially
dangerous objects from the floor such as glass, lamps, wires, curtains, valuables
and jewelry, hairpins, debris, etc. The vacuum cleaner is able to bridge obstacles
up to 18mm high.
Please take care of children and the elderly when cleaning in order to avoid
injury.
If the body of the vacuum cleaner becomes too hot during charging, you
should stop charging. Do not use the vacuum cleaner battery to recharge other
devices. Do not close contacts or disassemble the battery.
Turn off the power to the device, if it's not operated for a long time. The device
will operate on a schedule, if it is always turned on and charged.
Charging Before Initial Setup
The device shall be initially charged for at least 12 hours. The following two
options for charging are available:
• Using the power adapter: Turn on the vacuum cleaner using a switch ⓮ (See
Figure b) and connect the power adapter ❹ to the vacuum cleaner power
port ⓯. Then, plug the power adapter ❹ into the mains socket. The
"Start/Stop" button
charging will sound;
• Using the docking station ❷ (See Figure c): plug the docking station into a
power outlet using the power plug ⓲. Align contacts at the bottom of the
vacuum cleaner body ❶ (between the side brushes ❼) with the contacts on
aeno.com/documents
will flash white, and a voice message on the start of
10