JOCCA Stule 1602 Manual De Instrucciones página 7

English EN
will flash and indicates a low battery status.
-Proceed to load the appliance as indicated below. (FIG.1)
-This device has a travel lock. To activate it, press and hold the
ON button for 3 seconds. Then the LED display of the shaver
will show that the block has been activated.
- Repeat the previous step to unlock. (FIG.2)
-This device has 5 interchangeable heads.
1. 5D shaving head.
-Turn on the appliance and use it as indicated below. (FIG.3)
-For a better shave of the head it is advisable to wash the head
and dry the hair. If necessary, clean the head with a brush.
-When the electric shaver is overloaded, it will automatically
shut down and the LED display will indicate. At this time, it
should be clean before use.
-When the faucet symbol flashes on the LED display, it indicates
that the electric shaver needs to be cleaned. (FIG.4)
-To clean the shaving heads, clamp the sides and lift the piece,
then put it under the tap.
NOTE: DO NOT IMMERSE IN WATER FOR A LONG TIME.
DO NOT DRY / CLEAN THE HEAD WITH PAPER OR CLOTH, IT
MAY DAMAGE THE PRODUCT.
-Once finished shaving, cover the head with the protective cap
to prevent damage.
2. Trimmer head for nose and ears
-Before trimming the hair, clean both the nasal canal and the
ear if with wax.
-Turn on the appliance and use it as indicated below. (FIG.5)
3. Facial cleansing brush.
-Removes excess sebum and dirt from the face.
-Don't clean your face directly with a dry facial cleanser, it may
irritate the skin. (FIG.7)
4. Silicone brush
- The silicone material, with a soft and delicate texture, adapts
well to the skin and cleanses the pores. (FIG.7)
5. Short hair head
-Trims and shapes facial hair. (FIG.8)
7