Publicidad
This product is manufactured in accordance with the requirements of the European Directive
2001/98/EC on General Product Safety, the Consumer Prorection Act and the European
Standard EN 1130: 2019.
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING!
•
Do not use this product without reading the instructions for use first.
•
Stop using the product as soon as the child can sit or kneel or pull itself up.
•
Placing additional items in the product may cause suffocation.
•
Do not place the product close to another product, which could present a danger of
suffocation or strangulation, e.g. strings, blind/curtain cords, etc.
•
Do not use more than one mattress in the product.
•
The product should be placed on a horizontal floor.
•
The young children should not be allowed to play unsupervised in the vicinity of the crib.
•
The crib should be locked in the fixed position when the child is left unattended.
•
All assembly fittings should always be tightened properly and that care should be taken
that no screws are loose, because a child could trap parts of the body or clothing (e.g.
strings, necklaces, ribbons for babies' dummies, etc.) which would pose a risk of
strangulation. Perform routine checks to make sure there are no loose, damaged or missing
parts.
•
The maximum internal size of the crib the mattress is intended for is 900/590 mm. The
length and width shall be such that the maximum gap between the mattress and sides and
ends does not exceed 2,5 cm.
•
The product shall be kept away from burning cigarettes, open fires and other sources of
strong heat, such as electric bar fires and gas fires.
•
The base of the crib can be tilted up to 30° to prevent any discomfort and danger of
suffocation of the child.
•
DO NOT use the crib if any parts are missing, damaged or broken. Contact MONI TRADE for
replacement parts and instructional literature, if needed. DO NOT substitute parts.
•
WARNING!Only use the mattress sold with this crib, do not add a
second mattress on this one, suffocation hazards!
•
Do not make any changes or improvements to the design of the
crib, as this may damage the crib and risk injury to the child.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative only.
Check the securing of the fixation after each operation.
COMPONENTS – ILLUSTRATION A: 1.Crib basket; 2. Textile shelf for accessories; 3. Crib
mattress; 4. Support crib tubes (2pcs); 5. Plastic joint (2pcs); 6. Side frames (legs) – 4pcs; 7.
Support tubes (4 pcs); 8. Bolts (4 pcs).
ASSEMBLY OF THE STRUCTURE – ILLUSTRATION B:
EN
ASSEMBLY INSTRUCTIONS
13
Publicidad
