NGTeco NG-C52002 Serie Guia De Inicio Rapido página 7

2. Make sure the Status LED blinks red rapidly, indicating that
Pairing Mode is active.
Note: If the device doesn't display the above status, press and
hold the Reset Button for 5 seconds until the Status LED
begins to flash red.
3. Open the app, tap the "+" button on the top right corner of the
interface, and then select the "Add Device" option. Select the
"Smart Camera" option and then choose the corresponding
model purchased.
4. Tick "Next" if you have finished the above steps on the
interface. The app will search the device automatically, and
then tap the "+" button to add the corresponding device.
Note: Make sure the smartphone is connected to the same
Wi-Fi network.
5. You can manually change the name of the device once you see
the message "Added successfully" on the mobile app. To
finish the setting, tap the "Done" button.
Step 3: Add the Cameras to the App
1. Open the silicon cover at the bottom of the camera.
2. To power the device, turn on the power switch. Wait a few
seconds until the Status LED blinks red rapidly, indicating
that Pairing Mode is active.
Note: If the device doesn't display the above status, press and
hold the Reset Button for 5 seconds until the Status LED
begins to flash red.
3. Open the Home Base interface, and then select the "Add
Device" option. Tick "Next" if you have finished the above steps
on the interface, then the app will search and add the device
automatically.
6