Sime SOLIDA 5 PL Manual Del Usuario página 15

The lever with the chainlet should be
introduced in the regulator holder after
having assembled the instrument holder
board and after having removed the plas-
tic lock. If the joint is taken out, which
fixes the lever with the chainlet, take
care in assembling it again in the same
position. After having placed the knob at
60°C, block the lever with the chainlet in
a slightly inclined position downwards,
so that the chainlet will be in axis with
the air gate damper.
For the adjustment of the "Thermomat",
which essentially consists in the deter-
mination of the chainlet length, proceed
in the following way:
– Place the knob at 60°C.
– Switch on the boiler with opened air
gate damper.
– When the water temperature of 60° C
is reached in the boiler, fix the chain-
let in such a way on the lever of the
air gate damper, in order to obtain an
opening of about 1 mm.
– Now the regulator is calibrated and
it is possible to choose the desired
operating temperature by rotating the
knob.
"REGULUS RT2" Regulator
The adjustment field is included between
30 and 90°C (fig. 8).
Follow the same instructions of the
"Thermomat" regulator for the assembly
and the activation.
1.2.8 HYDRAULIC CONNECTION DIAGRAM
Open expansion tank system
"THERMOMAT RT-C" Regulator
"REGULUS RT2" Regulator
LE GEN D
VE Open expansion tank
VS System safety valve 3 BAR - 1/2"
VM Mixing valve
VR Check valve
PI System pump
IR Heating system
IT
ENG
ES
PT
FR
NL
Fig. 7
GR
RUS
Fig. 8
Fig. 9
15