Waves ETB-129237.1 Manual De Instrucciones página 84

USE
1. Put some toothpaste on the bristles before activating the toothbrush by
pressing the switch button.
2. Put the toothbrush into your mouth and then place the toothbrush head
between the tooth and the gum.
3. Press the switch button to turn on the toothbrush. The toothbrush will
operate as followed.
1) The toothbrush starts running at the morning mode; its indicator light
illuminates in white. The toothbrush works at a full power. The vibration
frequency and the cleaning efficiency are high. It is recommended to use
the morning mode in the morning to clean the dental plaque produced at
night.
2) Press the switch button again WITHIN 5 seconds to enter the night mode,
its indicator light will illuminate in blue. The toothbrush works at a lower
power. The vibration frequency is lower. It is recommended to use the
night mode before sleep to care for the gum.
Alternatively, press the switch button again AFTER 5 seconds, the
toothbrush will turn off directly.
3) With no further operations in 5 seconds, the toothbrush will keep running
at the current mode and shut off automatically in 2 minutes. The current
mode will be saved and the toothbrush will work according to the saved
mode when turned on again.
Note: When turned on again and the toothbrush starts running at the
night mode, press the switch button again:
- WITHIN 5 seconds, the toothbrush will turn off directly. When turned
on again, the toothbrush will work at the morning mode.
- AFTER 5 seconds, the toothbrush will turn off directly. When turned on
again, the toothbrush will work at the night mode.
4. When brushing your teeth, gently move the toothbrush head back and forth
between the teeth slowly. The toothbrush will pause for a short while approx.
every 30 seconds to remind you to brush other sections of your mouth.
Note: There are two rows of teeth in the mouth and each row of teeth have
left and right sections, so that there are four sections in the mouth needed to
be brushed.
5. When finished cleaning teeth, turn off the toothbrush, rinse the toothbrush
head and bristles with running water and then dry them. Wipe the handle
with a towel.
CLEANING AND MAINTENANCE
CAUTION: Before cleaning, disconnect the toothbrush from the power source.
Rinse the toothbrush head with clean water at a temperature lower than 45℃ and then dry the surface of the
toothbrush handle with a towel.
CAUTION: Do not immerse the toothbrush into water. Never use poisonous cleaning agents.
CAUTION: Do not let water get into the charging port on the bottom of the toothbrush when cleaning.
CAUTION: Do not put any part of the product into the dishwasher for cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the toothbrush.
CAUTION: Please do not use a deformed toothbrush head or a toothbrush head with bent bristles.
CAUTION: Replace the toothbrush head every 3 months or sooner if signs of wear appear.
Clean the toothbrush head
1. Rinse the toothbrush head and bristles with running water after each use.
2. Remove the toothbrush head and clean its inside surface with warm water at least once a week.
- 83 -