70mai Hiker 400 Guia Del Usuario página 7

• When power station is running, press this button twice in a row to enter SOS
mode. Press again to exit the mode.
15. LED light
LED light can be used for illumination or sending SOS signal. The brightness and
color temperature can be set in the app.
LCD display
1. Current input: Total power of input.
2. Remaining battery power: Current remaining battery power.
3. Battery level ring: Indicates the current battery level. If the battery level is
lower than 10%, all segments will turn off. In this case, recharge the power
station immediately.
4. High temperature alarm: Indicates that the battery temperature of power
station is too high. All output and input work will stop. Leave the power
station to cool to room temperature and then restart it.
5. Low temperature alarm: Indicates that the battery temperature of power
station is too low. All output and input work will stop. Move the power station
to a warm place and wait until it returns to the operational temperature and
then restart it.
6. Current output: Total power of output.
7. Timing icon: When AC/DC ON or OFF timer is set in the app, this icon
displays.
8. ECO (Auto turn off output for no load): Indicates that this function is
enabled. The output ports (excluding Type-C port) of the power station will
automatically turn off when the output is idle or at low load*.
This function can be disabled by pressing the function button or via the app.
You can set the duration of no load or low load according to your usage in
the app.
When the power station is turned on by accident or not turned off in time
after completion of normal use, it will continue to run, which may cause
continuous consumption of battery power or even depletion of power,
please keep this function on if you want to avoid such circumstances.
Disable this function if you have a low-load device ready to work continuously
for a long time.
9. AC output working frequency: Within 10 seconds after the AC output
is enabled, press and hold the AC output button for about 3 seconds to
change to appropriate AC output working frequency according to the actual
situation of the country and region.
10. Output overload alarm: When the output power of any output port exceeds
the maximum limitation, this icon displays and output will be turned off. In
this case, disconnect the supplied electrical equipment from the output port
and then restart the power station.
11. Recharging/discharge time: The remaining working time or recharging
time for the power station. The value is determined based on the
remaining battery power and total output/input power. If an error occurs,
troubleshooting code will display in this position.
12. Mobile icon: Indicates that the power station is connected to the Bluetooth
of the mobile phone.
05