Publicidad
S 6 5 5 S M A RT A DJ U S TA B L E B E D B A S E
Pairing and Synchronizing
Part 2: Pair Your Remote Control with a Base
Follow these steps to pair a remote with one or more bases.
1.
Make sure your base is plugged into an outlet.
2.
On the Power Supply Cord, locate the blue button.
3.
On your remote, locate the Head Up and Foot Up buttons.
4.
Press and release all three buttons simultaneously until you hear three beeps.
Part 3: Synchronizing Two Bases (Optional)
If you have split bases, follow these instructions to move both sides with one remote control in a synchronized manner.
Skip this step if you don't have split bases.
1.
Make sure each remote control operates a respective side (i.e., Remote A controls Base A and Remote B con-
trols Base B).
2.
Pair Remote A with Base B following the pairing instructions in Part 2.
3.
Test moving both bases with Remote A. Remote B will no longer function.
For dual controls, activate Remote B by following these instructions.
1.
After pairing Remote A with both sides, take Remote B and press and hold the Head Down and Foot Down buttons
until the backlight turns on.
Within 10 seconds, press and hold the Head Up and Foot Up buttons on Remote A.
2.
3.
Test moving both bases with either remote.
Tip: You can also set up dual controls using the included Sync Cable. Learn more on page 21.
13
2: 2
2: 3
3
A
A
B
B
14
Publicidad
