Eclipse D5II Manual De Instrucciones página 11

- Assembling the speaker stand -
1
Install the clamp and pole to the base plate with the
hexagonal socket head bolt.
Tip
Align the positioning label on the pole with the positioning
label on the base plate.
2
Insert the speaker into the joint and tighten it with the
washer and hexagonal nut.
Caution
• • The speaker is heavy, so hold it with your hand when
installing it.
• • Place the speaker stand on top of a soft cloth when
doing this so as not to damage the speaker and the
floor surface.
- Routing the speaker wires -
1
Connect the speaker wires to the speaker.
Caution
When connecting the speaker wires, insert the ends of the
speaker wires correctly so that they do not touch
neighboring terminals.
Tip
If the speaker wires are routed through the clamp on the
stand when connecting the speaker wires to the speaker,
it will improve the outer appearance of the speaker.
(for diameter of less than 7 mm)
2 Base plate
1 Post
Align the labels
2
Base plate
3 Hexagon socket head bolt
Speaker
Washer
Hexagonal nut
Speaker stand
Speaker wires
- 5 -
1 Post
4 Clamp
Speaker wires
4 Clamp