Publicidad
Idiomas disponibles
Idiomas disponibles
PROPELLERS
Each propeller must be mounted at a specific site. A propeller must be mounted at
the location A and helix B is installed in the location B, as shown in the following
drawing:
BATTERY CHARGE
Connect the battery to charge USB cable provided in the accessories. During
charging the red light comes on. Once fully charged the light will turn off. Connect
the battery to the device following the connection diagram:
The approximate charging time is 60 minutes. The usage time is about 8-12
minutes.
- Keep batteries away from high temperatures, other electrical appliances, etc.
- Do not strike the batteries, or put them in water. Keep them in a dry place.
- Do not open the batteries
- Do not charge the battery longer than necessary.
PREPARATION FOR FLIGHT
Connect the battery in the battery compartment. Turn on the device and leave it in
the ground, on a flat surface. The lights will flash for pairing with the remote
control.
Turn on the remote control, move the switch-off until you hear "beep". Turn the
switch to the off position. At this time the device is connected to the remote and
lights will remain fixed.
CALIBRATION
Once connected the remote with the device, turn the right control anti-clockwise
and the lights will flash which means that the device is calibrated.
Publicidad
