Publicidad
Idiomas disponibles
Idiomas disponibles
General Information
- Install in vertical position away from possible water
infiltration.
- Install away from excessive heat sources
(i.e. exhaust manifolds).
- Install away from ignition coil. Pass the wiring
Harness away from high tension wires.
- Make good electrical connections, avoiding the
use of wire splicers. Solder and properly isolate
all connections.
- Do not open the simulator box, especially while
the engine is working or while the ignition key is
on the ON position.
A.E.B. is not responsible for damages to
persons or property resulting from tampering
of its devices by unauthorised personnel.
10 - 32
IS388 Rev. 071005 - 0
English
IS388 Rev. 071005 - 0
10-36
Publicidad
