Work Pro W WFS 1200 Manual De Uso página 5

FOCUSING PROCESS
1. When the lamp is just installed and turned on, due to not focusing, the light spot is gray commonly. Fig. 1
2. Turn the vertical and horizontal zoom screws (fig. F1), the light dot of the spot will move vertically and levelly
respectively. The light spot will be approximately like fig. 2 and fig. 3.
3. Turn the vertical and horizontal focusing screws continually until to move the light dot to the center of the
spot, like fig. 4.
4. Turn the lamp´s focusing knob, enlarge the light dot and adjust vertical & horizontal focusing screws at the
same time, keep the light in the center, like fig. 5.
5. Turn the lamp´s focusing knob continually, make the light spot become the lightest and biggest, at this time,
the edge of the light spot is still hazy, like fig. 6.
6. Adjust the position the two focusing handles on the front and back (fig. F2), make the edge of the spot
become clear completely, like fig. 7.
7. When the two focusing handles are adjusted to the middle (relatively), the light spot is the biggest.
Fig. F1
Fig. F2
PAG. 4
User Manual/Manual de Instrucciones
EN
WFS 1200