RIKTA 30332959 Instrucciones De Montaje página 11

3
Mount the crossbeams (13) to the left table legs with the
screw/screw nut (4). The groove of the crossbeams must be
aligned inwards towards the bottom. Please loosen the nut
from the screw and insert the nut on the inside of the cross-
beam; insert the screw through the table leg from the outside.
Tighten the screw fi rmly with the enclosed Allen key (1).
4
In the next step, put the left table legs including the skid base
and crossbeam on the side and insert the shelf (7) into the
groove between the crossbeams.
5
Attach the right table legs including the skid base to the cross-
beams and repeat the procedure described in step 3 to attach them
6
Place the workbench on the skid base in order to mount the
worktop (12). Use the screws for this (3). Screw them to the
frame on the outer longitudinal side on the right and left res-
pectively with the holes for the vices facing forwards. Please
tighten the screws fi rmly.
17
7
Now turn the vice (17) into the desired opening of the
worktop. To do this, hold the vice horizontally and turn the
handle clockwise until the vice is correctly screwed into the
worktop. The guide rails (18) are preassembled under the
worktop for right/front and left/side use. For left/front or right/
sided use, you must change the guide rail (18) and the nuts (2)
accordingly. Simultaneous use for 'front-right / right-side' or
18
'front-left / left-side' is not possible!
18
107329 - 11 / 2021
11