JL Audio Gotham v2 Manual Del Propietário página 27

| Gotham
v2
®
max
On the Gotham v2's Front Panel:
Please turn off the home theater receiver or preamp/processor to make
these adjustments.
1. "Power" Switch
Flip each Gotham v2's "Power" switch to the "On" position.
2. "Lights" Switch
Flip each Gotham v2's "Lights" switch to the "On" position. If you don't
see any lights on the front panel, you may have forgotten to plug the
Gotham v2 in or there may be a problem with the electrical circuit.
3. "Input Mode" Indicator Lights
If you are using a single Gotham v2, confirm that its "Input Mode" indicator
light is on the "Master" position. If not, you will need to access the left
"Input Mode" switch on the rear panel of the Gotham v2. If you are using
multiple Gotham v2s in a Master/Slave configuration, confirm that the
unit connected directly to your receiver or preamp/processor is indicating
"Master" on its "Input Mode" lights and that all other units are indicating
"Slave" on their "Input Mode" lights. If not, you will need to access the
left "Input Mode" switches on the rear panels of the Gotham v2s.
4. "Level Mode" Switch
Flip the master Gotham v2's "Level Mode" switch to the "REF" position.
5. "LP Filter" Switch
If your home theater receiver/processor is handling bass management
(speakers set on "small") or if you are using an outboard crossover/
bass-management processor, flip the master Gotham v2's "LP
Filter" switch to "OFF." If not, select the "12 dB" position.
6. "LP Freq. (Hz)" Knob
Rotate the "LP Freq." knob to the "80 Hz" position.
7. "e.l.f. trim (dB)" Knob
Rotate the "e.l.f. trim" knob to "0"
8. "Polarity" Switch
Flip the "Polarity" switch to "0".
9. "phase (deg.)" Knob
Rotate the "phase" knob to "0" degrees
10. D.A.R.O. Defeat Switch
Press the D.A.R.O. defeat switch so that the
red light in the switch remains lit.
Pg 27 | EN